Author Topic: Putting EFI Engine into CI right gears  (Read 251 times)

0 Members and 1 Guest are viewing this topic.

Bmann19

  • Neophyte
  • *
  • Posts: 1
  • Karma: 0
on: January 15, 2020, 09:17:06 pm
Dear Enfielders,
I have 2 bikes;
1) a bullet 2008 350 standard Cast iron with gears on right side
And
2) a 2012 Bullet classic with 500 EFI engine

My question is can I fit the EFI 500 engine into my older bike??

I love the look of my older bike and but on the other hand I like the techy efi engine

Thanks in advance!



ace.cafe

  • Grand Gearhead
  • *****
  • Posts: 13,814
  • Karma: 0
  • World leaders in performance/racing Bullets
Reply #1 on: January 15, 2020, 09:25:35 pm
It might be possible, but it is not worth the effort. It would be a very big job. So many things would need to be changed and fabricated that it would be much easier and cheaper to use the EFI bike instead.

The frames are not the same, drive chain on opposite sides, wiring harness and electrical all different, new motor mounts to be fabricated, etc etc.
« Last Edit: January 15, 2020, 09:29:29 pm by ace.cafe »
Home of the Fireball 535 !


Adrian II

  • Grand Gearhead
  • *****
  • Posts: 2,057
  • Karma: 0
  • Sharing my ignorance with anyone who needs it
Reply #2 on: January 16, 2020, 12:25:11 pm
Just buy a B5 EFI Bullet, if you can get one, and sell the Classic?

A.
Grumpy Brit still seeking 500 AVL Bullet perfection! Will let you know if I get anywhere near...


bobscogin

  • Scooter
  • **
  • Posts: 64
  • Karma: 0
Reply #3 on: January 16, 2020, 03:02:39 pm
I asked that very same question a few weeks ago, and upon investigation I decided that it wasn't feasible. It's not difficult to make a newer Bullet look old with a few changes to the sheetmetal and chassis parts.

Bob