Description: Aluminum front fender, Bobbed rear fender, old English tail light. Ace Bars, EFI muffler, angle adapter, rear set pegs, 7" headlight, Dunlop K70 tires, AGM battery, bar end mirrors, smaller turn signals. Now what to do with tank and seat without breaking the bank. Bare
Picture Stats: Views: 1135 Posted by: barenekd December 16, 2011, 12:22:01 pm
December 18, 2011, 12:21:22 pmI'm not sure what I'm going to do with the seat. The rear loop for the seat mount is really the problem. It's too wide for most of my ideas. I can saw it off and weld a tapered loop back there so as to retain the fender mounts. I originally want just a tapered seat section back there, but it would look weird keeping the width. Thinning the rear foam down making it look a lot lower would be a possibility. I'm not really concerned with passenger seating. I'm not sure which way to go at this point.
December 18, 2011, 10:11:54 amAnd I also wanted to say I think how you shortened the rear fender looks PERFECT. It's a really nice line - much more so than the factory line, I believe. I'm really itching to follow suit.
December 18, 2011, 10:08:53 amSince we seem to be heading down similar roads style wise, I wanted to try a triumph-style flat bench seat. Just a few inches of padding. I think it might run into issues lining up right, considering the rear fender sits high. But I think that could look really cool. Just flat. Maybe there passenger part is gutted underneath to be barely anything. I only carry on occasion. You think you'll retain a passenger spot? That'll make difference on your direction.