[Crispyduck]

Hi Ace,

I read a post a few months ago about a new cylinder head that u were developing for the UCR that included custom rockers etc.

Is there any news on that? Is it now available?

Cheers

Crispy

[Crispyduck]

Sorry, i shouldnt type and drink beer at the same time. I meant UCE not UCR. 

[Guaire]

"I read a post a few months ago about a new cylinder head that u were developing for the UCR[E] that included custom rockers etc."

Crispyduck - Custom rockers would be the UCE Fireball #3. I have the ACE Performance cams to go with the Fireball head. I've been recovering from a mild flu these days. After I set up the Fireball with the new cams, I'll check the push rod length and order a custom length. Our push rods are oil fed from the hydraulic lifters. The 'squish mod' has been done. There are no problems with the valves/piston clearance.
  The Clubman Kit 1 and 2 are doing fine. The Clubman Kit 2 is great with the ACE cams. It's wall to wall mid-range. No flat spots.
https://forum.classicmotorworks.com/index.php?topic=7829.msg382828#msg382828

These days you can probably reach ACE.cafe at the Bullet Board Forum at Western Cycle Supply.
http://forum.westerncyclesupply.com/index.php?sid=378045f7f3f135ced705dc6cb096b940

Here's a pic of the Fireball, CGT 535, in situ, now.
Cheers,
Bill G

[Crispyduck]

Thanks for the Info Bill,

I sent a post out on the Bullet board forum. Hopefully ACE see's it.

Cheers

[Guaire]

Thanks for the Info Bill,

I sent a post out on the Bullet board forum. Hopefully ACE see's it.

Cheers

You might want to respond to the post that's already there.