Unofficial Royal Enfield Community Forum
Royal Enfield Motorcycles => Bullet with the UCE engine => Topic started by: Ragmas on August 31, 2010, 05:20:30 pm
-
I would like my bars to be pulled back a couple of more inches than they are. The ones on the bike are stock 2009 G5 Military. Does anyone know what bars would give a bit more pull back?
Thanks,
Sam
-
Most bike shops have a Tucker Rocky catalogue you can look in. Bike Master bars are around $25 and have different shapes. Measurements are given.
-
Here's a comprehensive catalog with measurements so take your pick. I wound up putting Kawasaki Police Bars on an Aprilia Falco street fighter!!
http://www.flandersco.com/about.html
-
I would like my bars to be pulled back a couple of more inches than they are. The ones on the bike are stock 2009 G5 Military. Does anyone know what bars would give a bit more pull back?
Thanks,
Sam
P/N 560538 .......
-
Ragmas: did you find the bars you were looking for? I'm in the same boat. Would like a bar like a beach cruiser bicycle might have.
-
P/N 560538 .......
I searched for this part number on Flanders site. Unable to find it. If you could post a link, I would like to see what it looks like.
Thanks.
-
I searched for this part number on Flanders site.
Aint a gonna' find it on the Flanders site, it is a NField part number.
-
Remember, you may need longer cables if you get way outside the stock bend/length.
Scott
-
I have not found bars yet. As it turns out I have a friend who has a friend with lots of motorcycle parts. I am going to get an assortment from him and see if I can make a go at it.
Sam