Unofficial Royal Enfield Community Forum

General Discussion => Tech Tips => Topic started by: Wojin on April 23, 2013, 06:16:11 pm

Title: 2003 bullet won't go into 1st gear
Post by: Wojin on April 23, 2013, 06:16:11 pm

I recently changed the front sprocket on my 03 bullet.  After reasembly the bike would not go into first gear.  Prior to this it was also a little difficult, however now it won't go in at all.  I am hoping this is not a major fix.  Anyone ever have this problem before?

Title: Re: 2003 bullet won't go into 1st gear
Post by: barenekd on April 23, 2013, 07:21:29 pm

Can't say I've heard of that happening because of the sprocket change. However, Since the side cover was off, remove it again and check the tang/fork assy where the shift shaft comes through the cases from the shifter arm. It sounds like that is probably a bit off there and hitting the case wall between it and the sprocket.
Bare

Title: Re: 2003 bullet won't go into 1st gear
Post by: mrunderhill1975a on April 23, 2013, 07:30:38 pm

Does your 2003 have a four or five speed gearbox?  Is the shifter on the left or right side?

Title: Re: 2003 bullet won't go into 1st gear
Post by: The Garbone on April 23, 2013, 09:33:13 pm

My first thought is clutch drag.  Does it shift with the engine off and rocking the bike? If so the clutch needs adjustment.  Just a shot in the dark....