Unofficial Royal Enfield Community Forum
Royal Enfield Motorcycles => Vintage Royal Enfield => Topic started by: maxy123 on May 31, 2010, 08:09:05 pm
-
Hi Guys
I would be grateful if anyone could tell me how to remove the
Advance/Retard plate from the distributor shaft on a RE Bullet 500. If
it is screwed on, is it clockwise or anticlockwise to unscrew?
Look forward to hearing from you
Thank you
-
Take the two nuts off that hold the cover on the distributor. They are right hand thread. then pull the plate toward you. ERC
-
if you mean the advance mechanism after removing the center bolt I just gave mine some gentle side to side taps with a brass hammer, it is a taper fit and should come apart easy.
-
Or you could send the puller screw down the center to pop it off the taper. The advance unit(if thats what hes talking about) is threaded internally .