[Moonwalker]

Hi
I would like to fit beston grips on to my mr clean gt 650 ,i dont have bar end mirrors ,can anyone tell me if this can be done ?
Thanks
D

[Yinzer]

Those look old school cool

[supercub]

Check the depth of the grips to the gap between the controls and end of bar, I believe the controls are pinned in place by seeing a photo of a disassembled one. If the grips are closed end and you want to keep the end caps, you can dremel out the grip ends, I've done it on soft Biltwell grips.

[JLewis]

I have them  but on aftermarket bars. 
Bear in mind that you'll probably want to shorten the throttle tube as it's longer than the grip if you want a neat look.
I haven't got around to that yet but will eventually.
 

[Moonwalker]

Thanks
It looks like ill bin the bar end weights and just fit the grips
Cheers
Dave

[Moonwalker]

Fitted the beston grips today ,done in 10 minutes
Regards
Dave

[Blazes Boylan]

What's the length?  Everywhere I look they seem to be 5.25" which is half an inch longer than the Biltwell Renegade grips that fit my Interceptor perfectly.  I love the look of the Bestons but can't trim them because I don't use bar ends.  If anyone knows a source for 7/8" Bestons in a 4.75" length please post a link.  Thanks.

[supercub]

They look great I like the style.

[Moonwalker]

Thanks
Ill have a look at the length measurnent and post it .
I decided to use the bar ends which meant getting the right size socket the same diameter as the old grip that cane off ,i drew a circle at the end of the new grip and used a stanley blade to carefully cut out the circle ,easy .
If i had binned the bar ends and not cut a hole at the end then i would have had to trim the throttle tube and there would be a gap between the switch gear and the grip on the left sde ,this way i can still fit the bar ends and bar end mirrors .
Cheers
Dave from Scotland

[Moonwalker]

Forgot to mention i used the quick method to replace them  sliced off the old ones and used my wifes hairspray to slide the new ones on .
Cheers
Dave

[Blazes Boylan]

Thanks
Ill have a look at the length measurnent and post it .
I decided to use the bar ends which meant getting the right size socket the same diameter as the old grip that cane off ,i drew a circle at the end of the new grip and used a stanley blade to carefully cut out the circle ,easy .
If i had binned the bar ends and not cut a hole at the end then i would have had to trim the throttle tube and there would be a gap between the switch gear and the grip on the left sde ,this way i can still fit the bar ends and bar end mirrors .
Cheers
Dave from Scotland

Thanks.  I found a pair of cheap Emgo lookalikes for $10.95 on eBay but the rubber is hard as hell, the inside flange is too small, and the length is only 4.5", which is a bit small for my hands.