3. Throttle cables
« previous next »
Pages: [1]   Go Down

Author Topic: Throttle cables  (Read 722 times)

0 Members and 1 Guest are viewing this topic.

Dacvulcan

  • Bulleteer
  • ***
  • Posts: 108
  • Karma: 0
Throttle cables
on: September 13, 2021, 07:28:52 pm
How do you get the throttle switchgear off of the handle bar? I have removed the two screws and loosened the cables. I don't see a pry point to get the two halves apart.
Logged
Northern Virginia USA
2020 INT650 Glitter & Dust

Previous bikes: Kawasaki Vulcan 2000, 1500 Vulcan Classic, ZG1000 Concours, ZG1200 Voyager, KZ1000 Shaft, KZ750M Twin, KZ750E Four; Honda XL600R. XL350, CB550F, SL350, CL350, 305 Super Hawk

Richard230

  • Grand Gearhead
  • *****
  • Posts: 6,051
  • Karma: 0
Re: Throttle cables
Reply #1 on: September 13, 2021, 10:05:34 pm
Quote from: Dacvulcan on September 13, 2021, 07:28:52 pm
How do you get the throttle switchgear off of the handle bar? I have removed the two screws and loosened the cables. I don't see a pry point to get the two halves apart.

There might be another small screw that you haven't found yet holding the assembly together.  ???
Logged
2018 16.6 kWh Zero S, 2009 BMW F650GS, 2020 KTM Duke 390, 2002 Yamaha FZ1

Slow

  • Scooter
  • **
  • Posts: 12
  • Karma: 0
Re: Throttle cables
Reply #2 on: September 14, 2021, 10:30:20 am
I had only two M5 bolts ( longer and shorter) and that hold both halfs together.
Exchange was possible without throtle body's bowdens loosing (only on handle bar)
Upper half has pin locate correct position on handle bar ( handle bar has hole).
Logged
Royal Enfiled is good example how to slow your hurry life :)

Pages: [1]   Go Up
« previous next »
  3. Throttle cables
 


  • The Unofficial Royal Enfield Community Forum website is a fan-driven project, not affiliated with Royal Enfield Motors.

Page created in 0.1 seconds with 35 queries.