Author Topic: Update on on oil catch can and sprag clutch  (Read 767 times)

0 Members and 1 Guest are viewing this topic.

African Boy

  • Scooter
  • **
  • Posts: 28
  • Karma: 0
on: September 15, 2024, 10:27:37 am
  Oil catch can and sprag clutch all in and working properly !  My next issue is the carb ? Will it work without the PAV connected as I don't have an airbox only a cone filter . The bike will start and run for a short time but as soon as I touch the throttle it cuts out ?  Is it too much air and not enough petrol getting through ?  Thanks again for all your replies much appreciated .


Adrian II

  • Grand Gearhead
  • *****
  • Posts: 4,524
  • Karma: 1
  • Sharing my ignorance with anyone who needs it
Reply #1 on: September 15, 2024, 05:44:25 pm
If removing the PAV system, or if someone has done it for you, check that ALL the holes left by its removal are plugged, on the inlet/carb mounting side as well as the exhaust.

A.
Grumpy Brit still seeking 500 AVL Bullet perfection! Will let you know if I get anywhere near...


African Boy

  • Scooter
  • **
  • Posts: 28
  • Karma: 0
Reply #2 on: September 16, 2024, 10:32:52 am
 Thanks Adrian , all good . It is starting well and running will have to try it down the road .