Unofficial Royal Enfield Community Forum

Royal Enfield Motorcycles => Bullet with the UCE engine => Topic started by: Ragmas on August 31, 2010, 05:20:30 pm

Title: Handle bars on a G5 Military.
Post by: Ragmas on August 31, 2010, 05:20:30 pm
I would like my bars to be pulled back a couple of more inches than they are.  The ones on the bike are stock 2009 G5 Military.  Does anyone know what bars would give a bit more pull back?

Thanks,

Sam
Title: Re: Handle bars on a G5 Military.
Post by: UncleErnie on August 31, 2010, 05:35:33 pm
Most bike shops have a Tucker Rocky catalogue you can look in.  Bike Master bars are around $25 and have different shapes.  Measurements are given.
Title: Re: Handle bars on a G5 Military.
Post by: jjoe256 on August 31, 2010, 07:08:35 pm
Here's a comprehensive catalog with measurements so take your pick. I wound up putting Kawasaki Police Bars on an Aprilia Falco street fighter!!

http://www.flandersco.com/about.html
Title: Re: Handle bars on a G5 Military.
Post by: ScooterBob on September 01, 2010, 01:10:37 am
I would like my bars to be pulled back a couple of more inches than they are.  The ones on the bike are stock 2009 G5 Military.  Does anyone know what bars would give a bit more pull back?

Thanks,

Sam

P/N 560538 .......
Title: Re: Handle bars on a G5 Military.
Post by: 3rdgear on September 26, 2010, 02:07:49 am
Ragmas: did you find the bars you were looking for?  I'm in the same boat. Would like a bar like a beach cruiser bicycle might have.
Title: Re: Handle bars on a G5 Military.
Post by: 3rdgear on September 26, 2010, 02:11:58 am
P/N 560538 .......

I searched for this part number on Flanders site.  Unable to find it.  If you could post a link, I would like to see what it looks like.

Thanks.
Title: Re: Handle bars on a G5 Military.
Post by: qgolden on September 26, 2010, 02:47:12 am
I searched for this part number on Flanders site. 

Aint a gonna' find it on the Flanders site, it is a NField part number.
Title: Re: Handle bars on a G5 Military.
Post by: Ducati Scotty on September 26, 2010, 06:42:01 am
Remember, you may need longer cables if you get way outside the stock bend/length.

Scott
Title: Re: Handle bars on a G5 Military.
Post by: Ragmas on September 26, 2010, 09:09:51 pm
I have not found bars yet.  As it turns out I have a friend who has a friend with lots of motorcycle parts.  I am going to get an assortment from him and see if I can make a go at it.

Sam