[PhilJ]

I have now adjusted my primary chain twice in 6300 miles.
The first time I adjust it for 5 mm by just lifting the chain until resistance was felt.
The second time I adjusted it at 5 mm by lifting the chain as far as it would go with a fair amount of force.
I wonder how it should be done, or does it even matter. I have noticed no difference, but would not like the find out the hard way that mine is adjusted too tight.

[Leonard]

You get it too tight and you should notice right away.  It will sound different and you will be down on power.  Not going to hurt if it is a little too loose, this chain should seldom needs adjusting.

[cyrusb]

Agreed, and make sure you check it a few spots,there will be a difference somewhere.

[Foggy_Auggie]

I check in about 5 - 6 positions using the bottom chain tension adjuster.  At the tightest spot, if I can just still feel the adjuster bottom bolt head raise a miniscule amount off the case casting (raising it up by finger) that's where it's set.

[PhilJ]

Thanks guys. It's probably OK but It's only oil, so I'm gonna check it again just to make sure.