Unofficial Royal Enfield Community Forum

Royal Enfield Motorcycles => Bullet with the UCE engine => Topic started by: Gypsyjon on April 01, 2013, 12:41:21 am

Title: Moose Racing Tach
Post by: Gypsyjon on April 01, 2013, 12:41:21 am

Installed my Moose Racing tach today. Used double sided tap to stick it right up next to the handle bar bolts. Nice clean installation, easy to see while riding.

It has been a great weekend for riding here in North Georgia.

Title: Re: Moose Racing Tach
Post by: Afro Samurai on April 01, 2013, 01:07:20 am

Slick...north ga you say...im in north ala...any group rides in your area?..wishfull thinking im sure...none around here...in ala atleast...only vintage cycle club...but not much activity...will see what the good weather brings...if it ever gets here...

Title: Re: Moose Racing Tach
Post by: Ducati Scotty on April 01, 2013, 04:02:30 am

No pics? :(

Title: Re: Moose Racing Tach
Post by: High On Octane on April 01, 2013, 04:22:33 am

What a teaser.  Where are the pics?  You can't install a new custom tach and not post pics.  Geeesh!     ;)

Scottie

Title: Re: Moose Racing Tach
Post by: Arizoni on April 01, 2013, 04:31:52 am

Without a picture, it didn't happen.

I think I saw that written in the rules somewhere? ")

Title: Re: Moose Racing Tach
Post by: Gypsyjon on April 01, 2013, 10:57:26 pm

I have always struggled to follow the rules......

Title: Re: Moose Racing Tach
Post by: motorat on April 01, 2013, 11:26:33 pm

what setting did you set it to?
i got a tto that was suppose to work for different #of cylinders.
i set it to .5 and at 60 it shows about 3800, if i remember right.

Title: Re: Moose Racing Tach
Post by: Gypsyjon on April 03, 2013, 01:21:47 am

This one has two different settings which differ from the TTO.

This guy was set correctly when I first fired it up. I had TTO but it absolutely fell apart before I got it installed. A little blue loctite and it was toast.