Right, yes will do.
So after pouring over my maintenance schedule there are a few things I'm unsure of. This is going to be a lot of questions, but please bear with me. I'm mechanically inclined, but clueless and a totally beginner with bikes- any advice is very appreciated:
Below is a list of items on the maintenance schedule and questions i have about them:
Eccentric Spindle - adjust when required. (where is this part? how to adjust?)
Inspect HT lead for crack - (i get it, now i'm a narcotics investigator, but what and where is the HT lead?)
Clean, inspect, and tune carb - (how invasive do i have to go here, which method to use?)
Clean fuel tap - (referring to the petcock? or what, and how to clean?)
Lube clutch actuating arm - (is this inside the primary case or where?)
Lube rear brake pedal pivot - (i get how to do it, but do i need to buy a grease gun, of can i apply it by hand?)
Inspect electrolyte level - (i've only looked at it during night time, but I can't see the electrolyte level through the side of the battery... do i have to take it out and open it up?)
That about wraps it up, thank you all very much in advance for helping a hyperactive novice.
Many thanks,
chuck