The attached pic shows what I felt impelled to do to my Bullet Sixty-5 tail light housing and license plate bracket. The stock item, as many may have noticed, points the tail light lens up at an undesireable angle. The housing, that fits againt the fender, was scribed and cut and repainted to make the tail light lens to be almost horizontal on its top surface. Alas, there is no easy way to actually get it properly level unless a lot more work is done. The area supplied for foreigner type license plates is far too large for any State of the Union plate. So it too was altered. A horizontal strip was cut out and the mounting plate welded back together.