Author Topic: Fold away footpegs  (Read 7671 times)

0 Members and 1 Guest are viewing this topic.

Sub

  • Bob's Your Uncle
  • Grease Monkey
  • ****
  • Posts: 435
  • Karma: 0
  • 2010 Black Bullet C5
Reply #15 on: July 16, 2010, 01:53:07 pm
Ya, sees 'bout it!


gashousegorilla

  • Grand Gearhead
  • *****
  • Posts: 4,485
  • Karma: 0
Reply #16 on: July 16, 2010, 05:30:59 pm
Ya, sees 'bout it!
Alright. when I get  spare moment this week, I'll pull it of the CB750, and try' er on the RE. ;)
An thaibhsí atá rattling ag an doras agus tá sé an diabhal sa chathaoir.


gashousegorilla

  • Grand Gearhead
  • *****
  • Posts: 4,485
  • Karma: 0
Reply #17 on: July 21, 2010, 01:52:42 am
Sub,It will work, but you will have to use the  the cb750 peg and arm, mine were from a 78'. But I would say earlier  and later models are probably the same. Remember though, on the right side, it will be right up against the header,so you will have to "adjust" the pipe and or put in some type of insulator, HOTFOOT!!, and your heals are going to be lower on both sides in relation to your gear shift and brake peddle.
 Good luck,let me know,
Dan.
An thaibhsí atá rattling ag an doras agus tá sé an diabhal sa chathaoir.


Sub

  • Bob's Your Uncle
  • Grease Monkey
  • ****
  • Posts: 435
  • Karma: 0
  • 2010 Black Bullet C5
Reply #18 on: July 21, 2010, 02:26:18 am
Thanks very much for the leg work.. did you happen to take any pics?!


gashousegorilla

  • Grand Gearhead
  • *****
  • Posts: 4,485
  • Karma: 0
Reply #19 on: July 21, 2010, 03:40:34 am
Thanks very much for the leg work.. did you happen to take any pics?!
No, I did not :-[, I'm a dope.
An thaibhsí atá rattling ag an doras agus tá sé an diabhal sa chathaoir.