Author Topic: Need a more powerful alternator  (Read 3673 times)

0 Members and 1 Guest are viewing this topic.

RBHoge

  • Old Bill
  • Grease Monkey
  • ****
  • Posts: 460
  • Karma: 0
on: July 04, 2010, 09:06:46 pm
If there is anything about my 2008 Iron Jug Bullet Deluxe that might be considered a disappointment, it would have to be the headlight. ??? At low rpms it is dim. at cruise it is adequate, ON LOW BEAM.  ;) High beam is worthless. :'(  When the bike was brand new I changed out the dinky 5 1/2 inch sealed beam OEM light for a 7 inch halogen kit from CMW.  The 5 1/2 was about as bright as a match in the wind. >:( The 7 incher can not be aimed, so the "High Beam" goes too high and completely off the road. ::) 

I want to add some "driving lights" (mounted to the engine guard) but I doubt that the stock alternator will handle the load.  :o The CMW catalogue shows higher output alternators for the Kick start models, but none for the ES.  :P Does anybody have a viable suggestion?
1972 Honda CB 450 Rufus, Murdered
1978 Triumph T-140 E, Sadly gone
2008 Royal Enfield Deluxe Iron head, " Old Bill"
1971 Honda CB-100,"Kikuchiyo"-traded
O Day 20 Sailboat "Tempus Fugative"
1992 Mazda Miata "Lady Murisaki"250,00miles!
Too many Toys, what else is retirement for?


Blltrdr

  • Grand Gearhead
  • *****
  • Posts: 2,079
  • Karma: 0
  • cycle-delic music
Reply #1 on: July 04, 2010, 09:48:05 pm
The SPX003 is the alternator kit I put in my Bullet.

http://www.tri-corengland.com/acatalog/Alternators.html

Check out the test results for the output of this alternator when compared to a standard unit.
2003 Classic 500 5 spd
2009 HD FLHT Police 103 6 spd
1992 Kawasaki ZG 1200 Voyager XII


enfield freddy

  • Grand Gearhead
  • *****
  • Posts: 695
  • Karma: 0
  • old man riding an old bike
Reply #2 on: July 04, 2010, 10:01:46 pm
are you lads in the USA using the AC/DC settup with an altenator with 4 wires , or are you just on DC with a 2/3 wire jobby?

arthritis hurts at my age!


baird4444

  • Grand Gearhead
  • *****
  • Posts: 2,167
  • Karma: 0
  • 2003 ES 500... 38,416 miles, I'm done
Reply #3 on: July 05, 2010, 01:54:54 pm
yes there are options...   I mounted an after market driving light and wired it thru the
bright circuit. It throws a lot better beam than my 5 1/2" did. Brother Bong
in S. Korea also mounted a set of driving lights...   I don't think the alt. would handle
them at idle but how much do we idle any way?
              - Mike
'My dear you are ugly,
 but tomorrow I shall be sober and you will still be ugly'
 - Winston Churchill


Rick Sperko

  • Grand Gearhead
  • *****
  • Posts: 905
  • Karma: 0
  • Milwaukee, WI
Reply #4 on: July 05, 2010, 05:10:11 pm
Switching the remainder of lights to LED allows more juice for the headlight. I believe I saw significant improvement when I did it.

-Rick
Rick in Milwaukee, WI

'06 RE Bullet Classic Iron
'63 VW Beetle Ragtop (also classic)
'66 Chris Craft Cavalier Cutlass 26'
'02 BMW R1150R


rideOn

  • Grand Gearhead
  • *****
  • Posts: 568
  • Karma: 0
  • And on the eighth day, God said...."Let's Ride."
Reply #5 on: July 12, 2010, 03:56:49 am
i plan to re-wire the entire thing with at least some 12 ga and better connectors and the resistance coefficient should change. if it doesn't make that big a difference with current flow, then spend the dough on high out alt.
'82 gs850gl
'08 v-star 650 classic


Blltrdr

  • Grand Gearhead
  • *****
  • Posts: 2,079
  • Karma: 0
  • cycle-delic music
Reply #6 on: July 12, 2010, 04:48:58 am
i plan to re-wire the entire thing with at least some 12 ga and better connectors and the resistance coefficient should change. if it doesn't make that big a difference with current flow, then spend the dough on high out alt.

Read this wiring article from Pete Snidal before you wire.

http://www.angelfire.com/biz/snwvlly/bikes/negwire.htm
2003 Classic 500 5 spd
2009 HD FLHT Police 103 6 spd
1992 Kawasaki ZG 1200 Voyager XII


rideOn

  • Grand Gearhead
  • *****
  • Posts: 568
  • Karma: 0
  • And on the eighth day, God said...."Let's Ride."
Reply #7 on: July 12, 2010, 02:37:30 pm
Read this wiring article from Pete Snidal before you wire.

http://www.angelfire.com/biz/snwvlly/bikes/negwire.htm
***i add this after a little cyphering***

NEVER, NEVER, NEVER just pull wires out, as suggested in the article. this comes from many years of high-tech electronic work. i would suggest marking the device's polarity, at least, via schematic or circuit tracing and label wiring, if necessary, before cutting wires. a benchmark, or safety net in this case, may be beneficial.

however, a good read. that's kinda what i'm thinking. there are no inspections in this state so i'm considering letting the blinkers go bye-bye. i already use hand signals.

it would be a consideration to wire the blinkers up as running lights, though. i've thought maybe some leds in the front blinkers, mounted to the frame with some bouncy/springy bushings so they appear to 'flicker' at oncoming traffic.

i keep the headlight on hi beam ALWAYS, so i thought i would do like the article says and wire the oem control to simply turn the headlight on and off for starting.

i am considering a good heatsink and a single rectifier and mounting up with the horn to receive good airflow.

thanks for the link, it's a good'ern
« Last Edit: July 13, 2010, 03:02:51 pm by rideOn »
'82 gs850gl
'08 v-star 650 classic


arindamcc

  • Scooter
  • **
  • Posts: 37
  • Karma: 0
Reply #8 on: March 27, 2013, 05:32:38 am
The SPX003 is the alternator kit I put in my Bullet.

http://www.tri-corengland.com/acatalog/Alternators.html

Check out the test results for the output of this alternator when compared to a standard unit.

Which regulator/rectifier you used with your sparx 3 phase stator ? if possible please post some picture.


Ice

  • Hypercafienated
  • Grand Gearhead
  • *****
  • Posts: 6,753
  • Karma: 0
  • Ride In Paradise Cabo, Don and Ernie
Reply #9 on: March 27, 2013, 07:14:27 am
Electronic flasher, l.e.d.'s and Bosch pn#  0 301 600 118  ;)
No matter where you go, there, you are.


barenekd

  • Grand Gearhead
  • *****
  • Posts: 5,516
  • Karma: 0
Reply #10 on: March 27, 2013, 05:00:49 pm
My G5 had a terrible headlight, so I ended up running a hot wire from the battery through a couple of relays and directly to the headlight. The wires from the dimmer switch controlled the relays. Worked great!
Bare
2013 Moto Guzzi V7 Racer
2011 Black Classic G5 (RIP)
I refuse to tiptoe through life only to arrive safely at death
http://www.controllineplans.com