I'm an Enfield rookie, my last bike was shaft driven, and the last bike I had that needed chain adjustment was done by pulling back the wheel (no cams, eyeballing alignment). So I haven't yet done a chain adjustment for my G5 yet. Here's my rookie question - when the manual says remove "brake rod nut," does that mean the nut on the end of the brake rod? Why must I remove it?Thanks for the help.
---but is the slackness on the top run, as per the book, or the bottom run??
Found it difficult to check for "dead-on wheel alighnment", but it looks OK from where I'm standing.
I use my laser level for this, have to use it for something. On a side note the batteries in my level are over 10 years old and the thing still works like a champ.. Why can't my TV remotes last that long?
Like the lazer, Len. Going to make one. Thanks.
Page created in 0.101 seconds with 32 queries.