hi folks, not sure if it is a tech tip as such but i have used a leingth of metal edge trim to go arround the tank seam to tidy it up, the sort of thing you used to get on car doors,it makes the tank look much neater, i bought 2mtr of 17mm edge trim from e-bay company called METAL EDGE ltd/or co,remove the seat and begin to bend it back slightly and feed it on to the tank lip from the tank mounts, follow the lip all the way round until you reach the other side of the mount, trim of the exess and replace the seatmake sure the trim is fully home on the lip all the way round and there you go done. also i noticed that the rear wheel throws a lot of crud on to the top of the swing arm and then onto the rear of the motor where the reg/rec lives and also some connector blocks, i got a piece of 2mm rubber sheet and some sticky back velcro and cut the sheet to fit inside the swing arm infront of the tire and used the velcro to fix it to the rear of the air box and also to the bottom of the canister/burp tank, no more crud throwen onto the electrics and swing arm.