Members Rides


Members Rides

NField Gear

30 Guests, 3 Users
ace.cafe, JohnDL, Mistgreen63
Welcome, Guest. Please login or register.
Did you miss your activation email?
May 25, 2016, 11:57:34 am

Login with username, password and session length


Author Topic: bar end mirrors  (Read 3435 times)


  • Neophyte
  • *
  • Posts: 10
  • Karma: 0
bar end mirrors
« on: August 18, 2008, 06:45:25 pm »
Well my bar end mirror won't fit. It only goes about half way through the clutch grip and won't tighten down, I think the nut is too big? And even if it would fit my clutch lever hits it. If I put it far enough out of the bike (3/4" of an inch) to avoid the lever than it is way too far out of the grip to stay in. And I would have to move the clutch lever really far to avoid the mirror, which wouldn't be a big deal if the mirror fit.   

Did I mention I had to cut my grip which now has a big hole in the end? And I don't see those grips on the website. They're hard and say "Royal Enfield" on them.

I guess I'll send it back, anyone have any ideas?


  • Neophyte
  • *
  • Posts: 29
  • Karma: 0
Re: bar end mirrors
« Reply #1 on: August 19, 2008, 07:53:06 am »
There is a rather extensive thread going also titled "Bar End Mirrors" in the Electra and AVL section of this forum.  You might want to check it out - it could have the answer you are looking for!

Bath Bullet

  • Bulleteer
  • ***
  • Posts: 224
  • Karma: 0
Re: bar end mirrors
« Reply #2 on: September 04, 2008, 03:11:26 pm »
There are a few people selling them (grips) on the British eBay site, one is that chap from India so I would imagine he would post to the US too?
Best regards
BITING THE BULLET:  2001 500 CLASSIC living in Sunny Bat, Somerset


  • Grand Gearhead
  • *****
  • Posts: 2,246
  • Karma: 0
Re: bar end mirrors
« Reply #3 on: September 12, 2008, 01:56:59 pm »

Do you have the Electra model? If you do I believe there is a weight in there to reduce the vibration. No sure if there removable. You may have to post in the classic or AVL threads.
« Last Edit: September 12, 2008, 02:01:51 pm by PhilJ »


  • Grand Gearhead
  • *****
  • Posts: 3,613
  • Karma: 0
  • Looking for the next rebuild project....
Re: bar end mirrors
« Reply #4 on: September 12, 2008, 06:29:07 pm »
  Had slight difficulty also installing them.  If you bought them from the Enfield store here they do fit.  Just have to muscle them abit.  On the clutch side move your control in about 3/8ths of an inch and it will clear the mirror.
Will Morrison
2007 500 Military
2000 Kawasaki Drifter 1500
2000 Victory V92SC
1976 Suzuki GT185 Rebuilder Special..AKA (Junkyard Dog)
Many, many other toys.
The garage is full.