Hagon shocks squeaking? I was considering purchasing a set of these but now I'm not sure anymore?
The squeak comes from the spring rubbing against the inside of the shroud every time the spring contracts or expands with the swingarm motion. Can't hear it under way, obviously, but when stationary, especially when mounting the bike before starting, it's rather annoying and not very cool. I can fiddle with the shroud angle and rotate things around so they're quiet, but they find their way back to rubbing in short order.Roeland, the shocks are silent without the metal shrouds installed - I just went for them because I like the look.I'm guessing a rubber o-ring would get muscled out of the way with spring movement, which is why I thought I'd go for a slippery plastic sheet lining of the shroud. But I spend a ton of money ( ) on plastic which I may have trouble gluing in place. Scott, double-stick may work, but I don't want to add too much thickness.I guess I'll just experiment with what I have and go from there...
I'm talking about putting the o-ring on the outside of the shroud. Nothing should touch it there.It might not work, but it has a chance at damping the noise, so, it might work.You could just tie a rubber band around the outside of the shroud, near the bottom open end, to see if it might have any effect. If it does, you could try the o-ring because it looks better, and hardly noticeable.
When you pay out what Hagons cost, they shouldn't squeak, or they should come with the slippery sheet already in place.
Page created in 0.107 seconds with 31 queries.