After doing a little off the blacktop riding it became evident that , for me, the foot pegs should be further toward the rear. To move the right side peg rearward it would be nice if the kick start arm was moved inboard as far as possible to give a little more foot room. As a megaphone exhaust was put on the bike it is possible, due to its narrower cross section in that area, to tuck in in even more than with the stock exhaust system. The attached photo shows the kick start arm, after being notched at top and bottom, bent to its new shape. The arrows point to the cuts. The cuts were then welded up and the chrome stripped off. Tomorrow it will be ground and polished and re-plated. I am fortunate to have a small plating set-up in the basement so the cost will be almost zero. With that detail complete the pegs should be able to be moved at least a couple of inches rearward.
[old attachment deleted by admin]