Author Topic: 2003 bullet won't go into 1st gear  (Read 1696 times)

0 Members and 1 Guest are viewing this topic.

Wojin

  • Scooter
  • **
  • Posts: 3
  • Karma: 0
on: April 23, 2013, 06:16:11 pm
I recently changed the front sprocket on my 03 bullet.  After reasembly the bike would not go into first gear.  Prior to this it was also a little difficult, however now it won't go in at all.  I am hoping this is not a major fix.  Anyone ever have this problem before?


barenekd

  • Grand Gearhead
  • *****
  • Posts: 5,516
  • Karma: 0
Reply #1 on: April 23, 2013, 07:21:29 pm
Can't say I've heard of that happening because of the sprocket change. However, Since the side cover was off, remove it again and check the tang/fork assy where the shift shaft comes through the cases from the shifter arm. It sounds like that is probably a bit off there and hitting the case wall between it and the sprocket.
Bare
« Last Edit: April 23, 2013, 07:37:04 pm by barenekd »
2013 Moto Guzzi V7 Racer
2011 Black Classic G5 (RIP)
I refuse to tiptoe through life only to arrive safely at death
http://www.controllineplans.com


mrunderhill1975a

  • Grand Gearhead
  • *****
  • Posts: 1,169
  • Karma: 0
Reply #2 on: April 23, 2013, 07:30:38 pm
Does your 2003 have a four or five speed gearbox?  Is the shifter on the left or right side?


The Garbone

  • Shade Tree
  • Grand Gearhead
  • *****
  • Posts: 3,978
  • Karma: 0
  • User Complaints: 22
Reply #3 on: April 23, 2013, 09:33:13 pm
My first thought is clutch drag.  Does it shift with the engine off and rocking the bike? If so the clutch needs adjustment.  Just a shot in the dark....
Gary
57' RE Crusader 250
67' Ford Mustang
74' Catalina 27 "Knot a Clew"
95 RE Ace Clubman 535
01 HD 1200 Custom
07 RE 5spd HaCK

* all actions described in this post are fictional *