One thing to know about taking anything for your Bullet to some machine shop is that nobody knows about Bullets, and you have to tell them specifically what to do, and double check everything after they do it.
I am in the tenn / north alabama area...So tell me more...who are the good bullet mechanics in this region ?...
Finally I got my head back from the machinist, with the new black diamond valves installed. I was going to smear some clay on top of the piston to be sure the valves weren't going to hit, but I dug out my box of sculpting clay and found it had dried out completely. So I shined a bore light down the compressor hole while looking down the spark hole and rotating the engine. Maybe not the best test, but it looked like there was plenty of space in there when at TDC. There should be anyway, with the 2mm spacer at the bottom of the barrel.Fired it up and wow... I was really impressed with how quiet the engine is now! Did my plug chops and put in some richer jets. Hope all is well from now on!
Page created in 0.093 seconds with 36 queries.