Doing a front-end swap for a disc brake fork. (Didn't need a disc up front per se, but my old fork sliders are shot and this was the only solution that didn't involve terribly suspect New Delhi made parts...)
Have to assemble the wheel. Hitchcock's has the parts diagram but I could use a little clarification.
Interior of the hub should be, from one side to the other: rubber seal, pressed-in bearing, inner spacer, pressed-in-bearing, rubber seal, correct?
Then the bushings go outside of these seals? (one cylindrical under the speedo drive, one stepped on the disc side)
How does the speedo drive mount up? Is it a friction-fit over the non-disc side bushing?
Anything else I should be aware of?
Thanks!