No, you don't need a rear dished plate. I have the same clutch pack on my 5spd. As long as the rearmost steel plate engages the splines on the clutch hub, you're fine.I was concerned about it, too, but the dealer showed me that it's how they come from the factory.
When did they change the design? Where did you buy your clutch pack? Never seen a factory clutch pack without the dished plates before. Who is the dealer you refer to? Surely don't want to lead someone down the wrong path. Please substantiate your claim with more info for the members here.
Okay, I have a clutch sitting here in my lap right now.If you look at the lining of the basket with the rivets in it, if that is new, it sits about a half-mm above the level of the circlip around the clutch hub.It will work if it's all new and unworn, up to the point where the half-mm of wear on the riveted lining gets below the level of the clutch hub circlip, and then the plate won't contact the lining in the clutch basket properly anymore, and there will be a warping action going on when the clutch is clamped on to the plates. There won't be full contact on the basket lining material anymore. The flat plate at the back of the stack there will get warped. You won't be able to adjust your clutch correctly.I also checked the parts book, and there is nothing in there about any model using a flat plate at the back of the stack.Whoever sold you these parts and fed you the line about them being correct was acting in ignorance, or just wanted to sell you what he had.
Page created in 0.23 seconds with 33 queries.