do *NOT* modify.
Hi Gremlin,
I did *NOT* modify.
I finally received the LED flasher in the mail, Installed the same and I am gratefully up and running.
Here is how it went.
1. Purchase the Led bulbs, LED Flasher and the DIODE KIT.
2. Install Diode kit
(Many THANKS to GREMLIN )
3. Install LED's, make sure they illuminate and work in the trafficator sockets. (if the LEDS illuminate, You are set. NOTE: Your LED's will Blink Rapidly, that's OK, The LED Flasher you ordered will remedy that Rapid flashing issue) If they DO NOT THEN
4. Reverse the polarity of the Individual Wires inside the Trafficators by reversing the wires. ( THANK YOU MATTSZ, GREMLIN & ARIZONI )
5. Check that all the bulbs work (The OEM Bulbs will also work as they are not sensitive/subject to the polarity change).
6. Install the LED Flasher and you are good to go.
All the above and the flasher unit I used are all from
www.superbrightleds.comModel: CF-12ANL-01 (2 Pin Black American Flasher) $12.95 (One Unit)
Model: MDK-1: Motorcycle Diode Kit $2.29 ( only one needed)
Model: 15-LED BA15S Bulb - 67-A: Amber $4.95 Each (you will need 4)
Thank You one and all for all the help.
Cheers
Mark