3. Rear wheel cotter pin size?
« previous next »
Pages: [1]   Go Down

Author Topic: Rear wheel cotter pin size?  (Read 950 times)

0 Members and 1 Guest are viewing this topic.

AgentX

  • Grand Gearhead
  • *****
  • Posts: 1,514
  • Karma: 0
Rear wheel cotter pin size?
on: May 27, 2012, 04:25:35 pm
Hi all--

Away from my Enfield on vacation but am buying some necessary stuff while I'm back in the States.

Can anyone give me the diameter of the cotter pin required to secure the castellated nut on the rear axle?  I want to use a hairpin type in the future.  Thx,

MD
Logged

barenekd

  • Grand Gearhead
  • *****
  • Posts: 5,516
  • Karma: 0
Re: Rear wheel cotter pin size?
Reply #1 on: May 27, 2012, 04:48:17 pm
The ones I use are an RCH less than 1/8"
Get the "R" (Hairpin) clip, then you won't ave to worry about it! ;)
Bare
Logged
2013 Moto Guzzi V7 Racer
2011 Black Classic G5 (RIP)
I refuse to tiptoe through life only to arrive safely at death
http://www.controllineplans.com

Ice

  • Hypercafienated
  • Grand Gearhead
  • *****
  • Posts: 6,753
  • Karma: 0
  • Ride In Paradise Cabo, Don and Ernie
Re: Rear wheel cotter pin size?
Reply #2 on: May 28, 2012, 11:34:57 am
Linch pins are another alternative.

Logged
No matter where you go, there, you are.

Pages: [1]   Go Up
« previous next »
  3. Rear wheel cotter pin size?
 


  • The Unofficial Royal Enfield Community Forum website is a fan-driven project, not affiliated with Royal Enfield Motors.

Page created in 0.061 seconds with 37 queries.