Hardly a monumental day. Got the tank stud buffer into the frame.
Mocked up the kicker and it clears the new footpegs when folded, so whoopee for that; shifter linkage rod will work, too. Filed out the mounting tabs on the tank so that the rear tank stud would actually pass through them.
And got stuck trying to replace the footrest support hex rod with a shorter one. (With the new peg position, it serves no purpose, so I just want to clean up the look instead of a long goofy bar with spacers sticking out into nowhere...)
I tried to drift the old one out using the new one to avoid any shifting of the engine mount plates, but that didn't work, and now I can't get the new rod through. Tomorrow I'm going to put both sides of the frame up on jacks, supporting the empty footpeg mount bosses, and hope that supporting the frame from there lets me get the rod through by flexing the 1mm or so I need to line things up.
Other than that, I mocked up the under-seat electrics tray and took a photo and labeled it so I don't forget! (attached)