I guess I have the only RE that leaks oil, just my luck.
Royal Enfield has a long and proud history of leaking oil.
You have the twin to my ride TW, right? I am taken mine in to Rons this weekend for some minor adjustments and her first oil change. If'n you want I can let him know bout you sight glass leak.
This is going to BE a problem if not addressed. The sight glass pushes into the case from the OUTSIDE and has no mechanical fixture to hold it there, other than a little friction on the rubber sealing ring. Any oil that gets past it is going to wet the seal and make it MORE prone to removing itself under the slightest crankcase pressure. I sent one flying across the room with 8psig as a test ... I made the suggestion that the sight glass should have an e-clip or a circlip or SOME sort of mechanical fixture to it .... but I guess a dozen or so "hard" improvements were enough. I'd take the thing to a machine shop and have a groove cut around the inside of the sight glass hole to allow mechanical fixing of the thing. That way, if it DOES leak - it isn't going to pop out and toss all the oil all at once .......
Jesus H. Christ, Bob, you really know how to scare a guy. Mine's not leaking at all and now I want to fix it!
OK, i have to mirror Andy on this one. Last thing I want is catastrophic failure doing 65, 200 miles from home. TW, i know you're about 200 miles away from Ron's. You think you will be able to get it up to him in time for the run? I'm going to keep an eye on mine as well as they both may have been manufactured at the same time in India, probably on friday. Keep us up to date.
Leaning heavily toward doing the repair myself, advice/assistance will be greatly appreciated. I never got around to getting a shop manual so I am depending heavily on support from this forum. When I remove the side case what am I going to see in there?
When I remove the side case what am I going to see in there?
Al nailed it. They replaced mine and it has been fine ever since. Probably a sloppy install at the factory. I like SB's circlip idea or even a dab of glue before it does anything nasty. Kevin was concerned because of past failures but said they haven't seen it on the UCE. Probably the same installer.
If you're pulling the side case order a gasket for that too.Scott
Page created in 0.124 seconds with 32 queries.